Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
instruite said:You cant make the Bulb just blink by using relay
You have to use the timer of the PLC, then use the contact of timers to switch the Bulb load
instruite said:http://www.plcs.net/chapters/time16.htm
instruite said:http://www.plcs.net/chapters/time16.htm
Timer Timer
-----|/|-----------------------( )
Timer Output Output
-----| |----|/|-----+---------( )
|
Timer Output |
-----|/|----| |-----+
Hi, i am also looking to turn on a light bulb once i activate an enable input the buld will light for 2 secs then go off for 2 secs then turn back on and repeat the cycle as long as the enable input is active. any ideas?