ok built it this evening and ill went together wery neat and easy, i have a primary signal but no secondary signal.
i hooked a 2 stage 6 pos rotary switch in the counter loops so i can change the count settings and a pot to alter the rpm. but i think i have the wrong connection for the of the counters
O0 i have used pin 3 zero count output?
the R i have used pin 15 reset (hooked to pole of my switch to loop back different count intervals)
input i have used pin14 clock
maybe i need to put clock enable pin 13 to earth or something??
pics are attached, it will all go in the little box when its done
also why is the signal a bit of an odd shape
cheers
i hooked a 2 stage 6 pos rotary switch in the counter loops so i can change the count settings and a pot to alter the rpm. but i think i have the wrong connection for the of the counters
O0 i have used pin 3 zero count output?
the R i have used pin 15 reset (hooked to pole of my switch to loop back different count intervals)
input i have used pin14 clock
maybe i need to put clock enable pin 13 to earth or something??
pics are attached, it will all go in the little box when its done
also why is the signal a bit of an odd shape
cheers