RadioRon said:The next step to fix these problems is to change the connection point of R1 and of R2. For example, with R1, you should disconnect it from the top of L1 and create a "tap" on L1 about 1/10 from the bottom (that is, 10% of the total number of turns of wire) and then connect R1 to that tap. Similarly, disconnect R2 from C5/L3, create a tap on L3 at the same height as you did for L1, and reconnect R2 there.
By the way, I did not assign the Q of the coils during simulation, will it cause my simulation to be inaccurate? Should i do the simulation without coupling the source impedance and load impedance?
Last edited: