Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Connect your GLCD as the schematic in the Unicorn manual has it. (GND the CD3 & 4 lines). Add a couple of 0.1uF caps to the VDD & VSS pins on the 18F4550 if you haven't already.
You have your contrast pot connected incorrectly. Pin 20 is -VEE (out)
the pot should be around 20K and one end to +5, the other to pin 20 and the wiper to pin 3.
i'd made a development board already
just to connect my hardware to the port only
I do not have 20k pot so can i series 2 10k together?
do u mean that the wiper is the center pin of the pot?
so 1st pin is vdd,2nd pin is pin3 and 3rd pin is pin20?
am i correct?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
