MrDEB
Well-Known Member
Been working on this for awhile. Originally was to have an 18 pin as well as 40 pin sockets.
Daughter board plugs into headers and is comparable with the TAP-28
ThrowAwayPIC
or at least I am pretty sure it is. Used the basic design added more LEDs, a dip switch so solder jumpers are not needed.
I know it isn't pretty and it checks out electrically so hopefully it ALL works. Most of the headers are new salvage (brown ones)
Now just need to figure out how to use the JUNEBUG to connect to the UART plug on my PDB-40 (the UART plug is connected =
RB1(int1) / 5+ / grd/RC6(TX)/ RCC7(RX) / RB2(int2)
**broken link removed**
**broken link removed**
**broken link removed**
Daughter board plugs into headers and is comparable with the TAP-28
ThrowAwayPIC
or at least I am pretty sure it is. Used the basic design added more LEDs, a dip switch so solder jumpers are not needed.
I know it isn't pretty and it checks out electrically so hopefully it ALL works. Most of the headers are new salvage (brown ones)
Now just need to figure out how to use the JUNEBUG to connect to the UART plug on my PDB-40 (the UART plug is connected =
RB1(int1) / 5+ / grd/RC6(TX)/ RCC7(RX) / RB2(int2)
**broken link removed**
**broken link removed**
**broken link removed**