If I have a 6 volt power supply, and a 2.7K ohm resitor. There is nothing in the circuit but the resistor. If I put my multimeter in Amp mode on the 20mA setting and I measure inline with the circuit(1 lead on the + from the power supply and 1 lead on one end of the resistor) I should get a reading correct?
I don't know if there is something wrong with my multimeter or what, but I don't get a reading on any of the settings. I do get one if I put it on the 10A setting(the + testing lead goes in a different port) and measure across the power supply. I know thats not good, but i get a reading on that. Any help?
I don't know if there is something wrong with my multimeter or what, but I don't get a reading on any of the settings. I do get one if I put it on the 10A setting(the + testing lead goes in a different port) and measure across the power supply. I know thats not good, but i get a reading on that. Any help?