geko
Active Member
For some reason it appears that in MPLAB 8.20/a when you use the quickbuild option without a project it's now invoking the linker.
It's not done this in any previous versions that I'm aware of and now with 8.20 the linker falls over on the the fill command in this bit of test code. If you quickbuild it using MPLAB 8.15a it assembles fine.
Without getting into the whole relocatable/reusable code argument I don't really understand why the linker is being invoked when the Quickbuild is being run outside of a project.
Is this a just happening to me or is it a 'feature' thats wound up in the latest release of MPLAB and if so anyone know a work around short of going back to 8.15?
It's not done this in any previous versions that I'm aware of and now with 8.20 the linker falls over on the the fill command in this bit of test code. If you quickbuild it using MPLAB 8.15a it assembles fine.
Code:
list p=12F683
#include <P12F683.inc>
__CONFIG _CP_OFF & _CPD_OFF & _BOD_ON & _PWRTE_ON & _WDT_OFF & _INTRC_OSC_NOCLKOUT & _MCLRE_ON & _FCMEN_OFF & _IESO_OFF
org 0x000
nop
nop
fill (nop), 0x7FF-$
end
Without getting into the whole relocatable/reusable code argument I don't really understand why the linker is being invoked when the Quickbuild is being run outside of a project.
Is this a just happening to me or is it a 'feature' thats wound up in the latest release of MPLAB and if so anyone know a work around short of going back to 8.15?
Last edited: