Hello, I'm new to this forum so appologies if this is in the wrong section...
I have a 10Watt guitar amp, well it is a combo actualy (has the speaker in the same box). But, I want to use as many parts from the 10W as I can to make an amplifier for use with a cabinet. If you don't know what a cabinet is, it is the speaker the amplifier plugs into.
So, can you instruct me on this, I'd prefer not to do my own PCB etching (perhaps use the old amplifier parts). I'm aware I'd need a heatsink as the other one (if any) probably is'nt very good...
Thankyou
I have a 10Watt guitar amp, well it is a combo actualy (has the speaker in the same box). But, I want to use as many parts from the 10W as I can to make an amplifier for use with a cabinet. If you don't know what a cabinet is, it is the speaker the amplifier plugs into.
So, can you instruct me on this, I'd prefer not to do my own PCB etching (perhaps use the old amplifier parts). I'm aware I'd need a heatsink as the other one (if any) probably is'nt very good...
Thankyou
