LTSpice Simulation Question

Status
Not open for further replies.

Raventrob

New Member
Hello All,

Currently I've been doing some parametric sweeps with components and temperature. If I perform both a parametric sweep with a temperature sweep is there a way to extract or plot the data for one of the temperature points? For example lets say I perform a transient sweep while measuring "Vout" and stepping a resistor over some range while simulating ".temp 0 100 10", can I plot or extract lets say just the data for 50C?

Thank you
 
I didn't think so, but just trying to make a one stop all simulation for a P1dB compression curve for various temperatures instead of having to rerun separately for different temps.
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…