bigal_scorpio
Active Member
Hi to all,
I was pondering if there was a prefered way of using logic gates to prevent two relays that control a motors direction from energizing at the same time?
Or is there an ideal way of using the relays themselves to do this, they are DPCO relays.
I was thinking logic to prevent any possibility of the relays lag from moving causing a problem.
Any suggestions guys?
Al
I was pondering if there was a prefered way of using logic gates to prevent two relays that control a motors direction from energizing at the same time?
Or is there an ideal way of using the relays themselves to do this, they are DPCO relays.
I was thinking logic to prevent any possibility of the relays lag from moving causing a problem.
Any suggestions guys?
Al