Latch Circuit Modify Help

S

Suraj143

Active Member
This is a latch circuit with a reset button.The circuit works fine.

For the reset button we don't have Normally close type switches in my area. that's why we use a relay with a Normally open switch.

I want to replace the Relay2 with an electronic component. How to do that?I need to build 300 pcs from the below circuit.
 

Attachments

Can you get a spring-loaded SPDT switch (or SPDT micro-switch)?
 
I can not see your attachment, can you send it in something other then a .BMP file?
 
How about this: Uses two NO momentary switches...



You could get by with only a SPDT relay
 
Last edited:
You beat me to it, Mike. I was working on virtually the same solution (but the PNP version)
 
Hi

Energize the relay on +12 side thru a resistor on neg side. Latch thru NO relay contact to +12. Connect +12 thru NO button to neg side of coil. Shunt the relay coil with +12v thru NO button to reset (because +12 on both sides of coil when reset is pressed)?

eT
 

Wouldn't that require a 6V relay on a 12V circuit, with a power wasting resistor?
 
MikeMl said:
Wouldn't that require a 6V relay on a 12V circuit, with a power wasting resistor?
Click to expand...

I call it "power saving resistor".
Could choose a resistor value that would still allow must operate voltage across coil.

eT
 
Sorry. I meant post #9 in this thread.
 
You must log in or register to reply here.

Similar threads

R
  • Question Question
Help needed for Induction Heater circuit
2
Replies
27
Views
7K
Tony Stewart
P
  • Locked
  • Question Question
Modify circuit to power on/off Attiny85 by remote
Replies
16
Views
8K
Nigel Goodwin
  • Question Question
Help in reduce circuit losses
3 4 5
Replies
82
Views
20K
vidalv
W
  • Question Question
circuit question number one.
Replies
11
Views
4K
shokjok
S
J
LED circuit for 1/6 scale diorama
2
Replies
33
Views
6K
eTech
E
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…