i got confused over "Do not tie the unused outputs to either rail. Leave them disconnected" i thought u said put them all to ground but then again i am assuming cuz of pulldown resistor i don;t have to. And lol i am putting JK to +V i even show that in my pic (except for J2, K2, but then again i am connecting them to +V along with Clock2) and yea i would appreciate if u can draw a debouncer circuit for my circuit along with pull down. And yea i thought pulldown resistoris connected to ground and pullup to Vcc, (correct me on that). Btw i put a pulldown from clock input since 555 timer output is basically my switch so and, correct me if i am wrong, 555 timer like u said is cud work as a debouncer so i thought pulldown resistor should be connected to that. So which is again y i am requesting u a debouncer circuit. I think if it wud be better if u edited my circuit pic and add debouncer there.