Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
3B6 are one of our competitors.... They are an Italian spin off from PAT who also do vehicle weighing systems..
I designed the Timotex fork truck weighing system and also do my own.. Going off the pictures.. If it used to have 5 legs it would be the switched mode regulator... Going off the coil, cap and schlocky diode... It looks similar to mine...
I use the LM2576t-5... But it could be any... If this is blown apart the input voltage has been exceeded as they have inbuilt current shutoff.... If it is a switch mode regulator they normally have an input range of Vout+2 ~ 40v.... If your truck is a 50V truck there is a 60v version...
I have friends that know all about 3B6 systems, But I can't contact them until Monday!!!
3B6 are one of our competitors.... They are an Italian spin off from PAT who also do vehicle weighing systems..
I designed the Timotex fork truck weighing system and also do my own.. Going off the pictures.. If it used to have 5 legs it would be the switched mode regulator... Going off the coil, cap and schlocky diode... It looks similar to mine...
I use the LM2576t-5... But it could be any... If this is blown apart the input voltage has been exceeded as they have inbuilt current shutoff.... If it is a switch mode regulator they normally have an input range of Vout+2 ~ 40v.... If your truck is a 50V truck there is a 60v version...
I have friends that know all about 3B6 systems, But I can't contact them until Monday!!!
If the system is only 12v, is it possible that welding has taken place whilst the battery was still connected???
Another reason is a dead battery being charged by what we used to call in the trade "demon charger".. These are chargers where the diodes have gone and unknown voltages are being used..
One last cause is the alternator itself... These things also suffer from blown diodes... It is possible that a rouge negative voltage has destroyed MORE than the regulator...
Was this fork lift inspected at all before you bought it??? It must have been very cheap!!not disconnected battery welding is posible... becouse we found alot of place where was welded. We laughed a lot when saw they just put a steel plate to mask metal crack's. cheaters repairers.... This is very unprofessional.
My advice is take out all the parts burnt and use any replacement 5V SMPS regulator with 10-15V input.problem is we bought a fork lifter "genie gth 2506" and found that load indicator View attachment 92442 View attachment 92444 dead. one peace fryed. how to find name of that peace to replace it? how people find out names that cant read becouse too much damaged part..View attachment 92443 View attachment 92445 View attachment 92447.