How to connect wired to stripboard

Hi,
I'm using a stripboard for my project and I need to easy run wired to different boards, for example I need to run 6-7 wires from an arduino board, 3 wires from a rfid module, 3 wires from a servo, etc. My question is what is the best solution for connecting the wires to the stripboard? I don't want to solder them to the board (hard to take apart). I need a solution that is easy to implement, cheap and that I can use in the end product too.

Thanks.

Header connectors.

Ken

SparkFun Electronics - Jumper Wires Premium 12" F/F Pack of 10

Female to female headers. Those are single ones but you can get single/double row, 2-20 way. They work with standard 0.1" headers which are on your arduino, and which are often used as connectors on stripboard. I have loads of these, sometimes its cheaper to get them from ebay.

Also, check out the molex connectors here:

**broken link removed**

They require crimps, but are very reliable, work with latched as well as standard headers, and I have used them in final products.