Help!!!

Status
Not open for further replies.

Percy2002

New Member
3.1 A shunt regulator using a Zener diode with rz = 5 Ω is fed through an 82 Ω resistor. If the unregulated power supply changes by 1.3 V, what is the corresponding change in the regulated output? (Sketch a diagram to answer the question). [4]
3.2 A full-wave bridge rectifier with a 1 kΩ load operates from 220 V/ 50 Hz supply using a 10:1 transformer.
3.2.1 Sketch a labelled circuit diagram indicating all components and polarities. [4]
3.2.2 Calculate the peak rectified voltage across the load. [2]
3.2.3 Find average DC voltage across the RL. [2]
3.2.4 A filter capacitor C = 470 µF is connected in shunt with the bridge and the load. Calculate the vrpp and resulting VDC (VL). [4]
3.3 DC measurement on a power supply has a terminal voltage of 12 V when loaded with a 1 kΩ load resistor. The terminal voltage drops to 10 V, when loaded with a load resistance of 100 Ω. Find the load regulation. [4]
 
Welcome to ETO, Percy2002!

Unfortunately, this sounds (and looks) like a school assignment post.

Ordinarily, members don't answer these...

That's your job.
 
If you come up with a proposed solution, post it, we might make suggestions. But only after we see your best effort...
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…