Hi,
I'm designing a PCB using Diptrace software on a single layer design, but after routing, I found that there's alot of paths which are not connected. It requires additional jumpers to connect those paths.
I've tried to place the components on different places, but it still end up the same. And this is my circuit:
Any advice to solve this?
I'm designing a PCB using Diptrace software on a single layer design, but after routing, I found that there's alot of paths which are not connected. It requires additional jumpers to connect those paths.
I've tried to place the components on different places, but it still end up the same. And this is my circuit:
Any advice to solve this?