Hi all,
I’m new to this forum and to PCB design in general. I am having difficulties identifying some old connectors. I’m trying to create an adapter board to replace an old PSU’s innards with modern ATX ones (the board in question will serve other functions as well...more on that later). The thing is, I’d like to reuse the same type of connectors, and I don't know exactly what they are since there's no schematic available for this old PSU. Anyway, here are the connectors:
The spade connector (left of 2nd pic) wasn’t difficult to identify. I’ll get measurements from the male connector and I’ll be able to find a new one easily.
On the other hand, I can’t find what the other single wire one is (the banana looking one). The male PCB connector is to the right of pic #1 (about 1cm high) and the wire/female connector is to the right of the second picture. Any ideas what it could be?
The third and last connector/receptacle appears to be a 2 pin Molex 5277 09-65-2029 (or compatible with at least, right?).
All three types of connectors are used to "transport" AC power (phase + neutral) from the C14 plugs at the back of the old PSU (one is a monitor pass through, the other is the power input) to the main board.
Any help deeply appreciated!
Thanks!
I’m new to this forum and to PCB design in general. I am having difficulties identifying some old connectors. I’m trying to create an adapter board to replace an old PSU’s innards with modern ATX ones (the board in question will serve other functions as well...more on that later). The thing is, I’d like to reuse the same type of connectors, and I don't know exactly what they are since there's no schematic available for this old PSU. Anyway, here are the connectors:
The spade connector (left of 2nd pic) wasn’t difficult to identify. I’ll get measurements from the male connector and I’ll be able to find a new one easily.
On the other hand, I can’t find what the other single wire one is (the banana looking one). The male PCB connector is to the right of pic #1 (about 1cm high) and the wire/female connector is to the right of the second picture. Any ideas what it could be?
The third and last connector/receptacle appears to be a 2 pin Molex 5277 09-65-2029 (or compatible with at least, right?).
All three types of connectors are used to "transport" AC power (phase + neutral) from the C14 plugs at the back of the old PSU (one is a monitor pass through, the other is the power input) to the main board.
Any help deeply appreciated!
Thanks!
Last edited: