Hi , I plan to use a GPS module at 115200 baud , as this is a high speed GPS receiver . I need this to connect it to atmega16 .
What I am doing is I get long/lat from the GPS and I need to compute approcahing distance from a pre-fed long/lat in the processor at 10Hz/GPS rate.
what I am finding it difficult to figure out is will it be possible to do all this with Atmega16@11.0592MHz XTAL? perfectly or will I face throughput problems .
Regards
Dark
What I am doing is I get long/lat from the GPS and I need to compute approcahing distance from a pre-fed long/lat in the processor at 10Hz/GPS rate.
what I am finding it difficult to figure out is will it be possible to do all this with Atmega16@11.0592MHz XTAL? perfectly or will I face throughput problems .
Regards
Dark