Mike - K8LH
Well-Known Member
I just received my 128x64 GLCD module and I can't figure out which connector I should put on it, the 20 pin SIP female or male. I'm thinking the female connector is probably more expensive so it should go on the display which would then allow me to install the less expensive male SIP connectors on a few different project boards.
What do you guys think? Is there a 'convention' of any sort that suggests which type of connector should be used on the display?
Mike
What do you guys think? Is there a 'convention' of any sort that suggests which type of connector should be used on the display?
Mike