Hello there,
I have a temperature sensor going from 1000ohm to 1700ohm resistance.This is my first time with a/d c, so I lack experience.
I have been trying different setups on my breadboard, and I am only able to utilize a range of circa 0.9v of the available 5v using a resistor.
Surely, as my adc accepts voltages from 0-5V, I should be able to make a circuit that allows my sensor to vary voltage from 0-5V so I may use full resolution.
How do I do this?
Thanks.M
I have a temperature sensor going from 1000ohm to 1700ohm resistance.This is my first time with a/d c, so I lack experience.
I have been trying different setups on my breadboard, and I am only able to utilize a range of circa 0.9v of the available 5v using a resistor.
Surely, as my adc accepts voltages from 0-5V, I should be able to make a circuit that allows my sensor to vary voltage from 0-5V so I may use full resolution.
How do I do this?
Thanks.M