fluke pressure lemo connector pinout

T

tfiket

New Member

• Jul 17, 2009

• #1

Hello, all. I have one pressure module from fluke (700P08) with broken wires inside, and since I have no idea which one goes where, PLEASE, if anybody out there has connection diagram or something, I would be more than grateful.
Regards, Tom

 

A

Ausinet

New Member

• Aug 13, 2017

• #2

Hi tfiket
Did you find a solution the lemo connections, I am in the same situation, I need to replace the cable to the Fluke 700P06 Pressure module. Does fluke service it. I would rather send it to them but let me know of any other options. Thanks to anyone who is able to reply

 

JimB

Super Moderator

Most Helpful Member

• Aug 13, 2017

• #3

Welcome to ETO.

Sad to say that tfiket was last seen here on 25th July 2008, rather a long time ago.

Hopefully someone else may have information on the connector.

JimB

 

A

Ausinet

New Member

• Aug 13, 2017

• #4

Hi JimB, Thanks for the reply, I have managed to source one from ebay and found the pin config as well. I have attached pin config to this reply as well.

 

Attachments

• 5 pin Config Fluke 700P06 Lemo FGG.0B.PNG

  622.2 KB · Views: 288

A

Ausinet

New Member

• Aug 13, 2017

• #5

Below is the link for the connector
**broken link removed**