Filtering PPG signal using Latis-pro.

Status
Not open for further replies.
I

imane tech

New Member
Hello Community!
I'm working on filtering a signal related to My heartbeat sensor, I used the FFT method in Latis-pro to see which frequencies I need to remove! You'll find down below the results that I had! I Found on the spectrum a weird result, a signal that has a frequency = 0 Hz.
 

Attachments

  • IMG_20220616_161959.jpg
    7.9 MB · Views: 221
  • IMG_20220616_161955.jpg
    2.7 MB · Views: 212
Sort by date Sort by votes
I think the biggest problem is that the signal resolution is so low.
If you cannot increase the signal level, can you reduce the ADC min & max references so they are nearer to the range the signal uses? That should give much better detail.

It's not obvious what the frequency or amplitude scales of the FFT are. There is a large DC (0Hz) component as it stays at the same few levels for many samples. It may be again that the FFT needs a wider input range to give a reasonable output.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

P
EasyEDA Pro change layer while routing manually.
Replies
7
Views
4K
schmitt trigger
S
P
  • Question
Has EasyEDA Pro killed the software?
Replies
16
Views
6K
For The Popcorn
F
F
  • Question
Eagle pro 7.4.0 cant put via on layer
Replies
4
Views
2K
technofreak
T
I
  • Question
Using the least mean method to filter the signal on proteus 8
Replies
6
Views
3K
Papabravo
printing a board using EASYEDA
Replies
13
Views
4K
MrDEB
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…