Areal Person
New Member
Hi,
Could someone please help me ?
I can't figure out how to use VIA's in Eagle.
I can't draw a signal from an IC pin to a VIA, It just will not work.
and If I try to use a wire it sayes there is a clearence problem on the DRC.
I've looked all over the internet, and reviewed several tutorails without
any luck.
I'm designing a Prototype board that has a large amount of VIA's
for a prototyping area.
Please help,
Thanks,
-Areal
Could someone please help me ?
I can't figure out how to use VIA's in Eagle.
I can't draw a signal from an IC pin to a VIA, It just will not work.
and If I try to use a wire it sayes there is a clearence problem on the DRC.
I've looked all over the internet, and reviewed several tutorails without
any luck.
I'm designing a Prototype board that has a large amount of VIA's
for a prototyping area.
Please help,
Thanks,
-Areal