Door Bell

Status
Not open for further replies.

Gregory

Member
I have been given KAMBROOK Wireless 12 V A27Battery Door bell transmitter and 240 Volt Receiver 50Hz 2W
The Range of the door bell is only 3M I have replaced the Battery in the transmitter but with no change .
How Can I increase the signal range as the power point for the receiver is 10 M away from the front door.
 
Try moving either the transmitting antenna or the receiving antenna a few inches. Due to multipath, you could be in a null. Moving either ~ 1/4 wavelength might fix it.

There may be some interference on the channel. I recently went through this with a similar wireless system which transmits on 433MHz. The neighbor has a burgular alarm base unit which transmits continuously, blocking my device.
 
I have the device in the same room looking at each other and the signal is not there at the distance mentioned.
I will post attachment for you to help me with this project.
The aerial on the receiver is that the copper loop at the end .
Do I have to cut this to increase the aerial length and join the loop together.
Where is the aerial on the transmitter.
Thank you for your Help
 

Attachments

  • IMG_3716.JPG
    483.2 KB · Views: 190
  • IMG_3721.JPG
    597.4 KB · Views: 165
  • IMG_3722.JPG
    477.2 KB · Views: 167
  • IMG_3725.JPG
    387 KB · Views: 170
Last edited:
Status
Not open for further replies.

Similar threads

S
Garage door closer
Replies
3
Views
1K
ZipZapOuch
  • Question
Project help request: Striking a bell manually, alarm clock.
Replies
12
Views
3K
stevef22
S
  • Question
Omnibus door controller build
Replies
4
Views
1K
Tony Stewart
D
Adapting garage door sensors
Replies
3
Views
2K
rjenkinsgb
A
Housing grommets for speaker/bell wire
Replies
3
Views
2K
rjenkinsgb
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…