gaspode42
Member
Hi
I am working on a project which requires the decoding of a PWM signal. I believe this can be achieved by looking for rising or falling edges (using CCP & a timer).
Am I correct in thinking that once the timer is running I have to manually poll the port to detect a state change and then stop the timer?
If anybody can advise or point me at a good tutorial/technote about this I would be most gratefull.
Chears
I am working on a project which requires the decoding of a PWM signal. I believe this can be achieved by looking for rising or falling edges (using CCP & a timer).
Am I correct in thinking that once the timer is running I have to manually poll the port to detect a state change and then stop the timer?
If anybody can advise or point me at a good tutorial/technote about this I would be most gratefull.
Chears