Hello forum,
I am thinking to make an isolated convertr using pushpull as shown below schematic.Please advise is there any drawback in using such a topology . I am making my own because board space / cost is constraint beside it has to meet explosion proof standard .The voltage I try is 3V to 3.25 volt isolation . I can see the regulation is rather poor because of no feed back . Is there any other problems that could arise with such a topology.
**broken link removed**
Thanks for your time.
PS: topology shown for reference only
I am thinking to make an isolated convertr using pushpull as shown below schematic.Please advise is there any drawback in using such a topology . I am making my own because board space / cost is constraint beside it has to meet explosion proof standard .The voltage I try is 3V to 3.25 volt isolation . I can see the regulation is rather poor because of no feed back . Is there any other problems that could arise with such a topology.
**broken link removed**
Thanks for your time.
PS: topology shown for reference only
Last edited: