Kryten
New Member
I got a couple of steppers from some old disk drives. They have a magnetic sensor that will give a count for every turn.
Im asking ( or trying to) if it would be possible to use these for positioning where a unit is (for my giga pan head). i need to count the number from center to top left and bootom right, frame size. Then calculate the number of stops needed (number of frames). I also need to count the number of frames taken in order to know where to stop.
Is this a big deal to program or can it be done easy??
Im asking ( or trying to) if it would be possible to use these for positioning where a unit is (for my giga pan head). i need to count the number from center to top left and bootom right, frame size. Then calculate the number of stops needed (number of frames). I also need to count the number of frames taken in order to know where to stop.
Is this a big deal to program or can it be done easy??