I went to the following site and found this little cnc plotter. (the second link is the layout diagram) the main page has the information of the circuit on it.
Homebuild Basic Plotter / Engraver / Vinyl-cutter / PCB-driller
http://www.luberth.com/plotter/layout.jpg
I would like to make one and wanted to know if i could change the layout. Instead of using a Centronics connector i wanted to know if it was possible to use a DB25 connecter instead. And if anyone had any layout ideas?
Homebuild Basic Plotter / Engraver / Vinyl-cutter / PCB-driller
http://www.luberth.com/plotter/layout.jpg
I would like to make one and wanted to know if i could change the layout. Instead of using a Centronics connector i wanted to know if it was possible to use a DB25 connecter instead. And if anyone had any layout ideas?