madhippiescientist
New Member
My work would kill me if they found out I ran a "photoetch"
sheet through a copier, especially if it jammed and/or melted
within it (their $20K copiers always jam anyways). I also am
not that crazy about the cost of "photoetching", and have
no experience in doing such.
Years ago I bought 2 sets of four sheets of "protective" dry
transfers with numerous different "symbols" from Radio Smack.
Theory, you rub them onto a CC board and etch the excess
with Ferric Chloride. I see large sheets of like symbols (all the
symbols on a sheet are the same) at Fry's Electronics, and
they're quite expensive, and offer little re variety of symbols.
Radio Smack hasn't had these things for years (at least within
my county, Maricopa, AZ). I'm running out of symbols! Does
anyone know where I can buy these things at now? Or even
something very similar?
The symbols typically entailed different sizes of; lines, donuts,
IC pads <w/ & w/o lines between>, multi-pin donuts <layed out
in a circular pattern and 3-pins for transistors>, etc. Anybody?
sheet through a copier, especially if it jammed and/or melted
within it (their $20K copiers always jam anyways). I also am
not that crazy about the cost of "photoetching", and have
no experience in doing such.
Years ago I bought 2 sets of four sheets of "protective" dry
transfers with numerous different "symbols" from Radio Smack.
Theory, you rub them onto a CC board and etch the excess
with Ferric Chloride. I see large sheets of like symbols (all the
symbols on a sheet are the same) at Fry's Electronics, and
they're quite expensive, and offer little re variety of symbols.
Radio Smack hasn't had these things for years (at least within
my county, Maricopa, AZ). I'm running out of symbols! Does
anyone know where I can buy these things at now? Or even
something very similar?
The symbols typically entailed different sizes of; lines, donuts,
IC pads <w/ & w/o lines between>, multi-pin donuts <layed out
in a circular pattern and 3-pins for transistors>, etc. Anybody?