I'm looking to get three PCBs made.
They are 60x15mm, single sided, no holes to drill, no silkscreen needed, no solder-resist needed. Minimum spacing/clearance is 13mil. So basically a very small, simple board.
However, I'm struggling to find somewhere that will make it cheaply. BatchPCB are the best I have found, at $10USD setup and $2.50 per square inch. However, that pays for two layers, two silkscreens, two solder-resists and unlimited plated holes.
That works out at $20 for the three boards, and I don't think that includes postage.
Futurlec do a basic service, costing $16 USD for a single sided board with no mask or silk.
Does anyone know anywhere where I can get these three boards made for any less than this? Any suggestions appriciated.
Thanks
Andrew
By the way, I'm in the UK.
They are 60x15mm, single sided, no holes to drill, no silkscreen needed, no solder-resist needed. Minimum spacing/clearance is 13mil. So basically a very small, simple board.
However, I'm struggling to find somewhere that will make it cheaply. BatchPCB are the best I have found, at $10USD setup and $2.50 per square inch. However, that pays for two layers, two silkscreens, two solder-resists and unlimited plated holes.
That works out at $20 for the three boards, and I don't think that includes postage.
Futurlec do a basic service, costing $16 USD for a single sided board with no mask or silk.
Does anyone know anywhere where I can get these three boards made for any less than this? Any suggestions appriciated.
Thanks
Andrew
By the way, I'm in the UK.
Last edited: