Hi,
I don't know if I am posting in the right category, so forgive me if I am not:
I recently purchased a Tektronix 2246 O-Scope. The unit was completely functioning until on one of my tests I forgot to connect the ground..... I was testing high voltage DC pulses. I don't know that much about O-scopes but I'm wondering how easy it would be to fix. My first guess is that I have just blown some safety components and need to replace them. I am confident enough to do it myself, but I just need to know more about this kind of issue. Again, not looking for a complete solution from this forum, just some guidlines, input and advice.
Thanks!
Enat
I don't know if I am posting in the right category, so forgive me if I am not:
I recently purchased a Tektronix 2246 O-Scope. The unit was completely functioning until on one of my tests I forgot to connect the ground..... I was testing high voltage DC pulses. I don't know that much about O-scopes but I'm wondering how easy it would be to fix. My first guess is that I have just blown some safety components and need to replace them. I am confident enough to do it myself, but I just need to know more about this kind of issue. Again, not looking for a complete solution from this forum, just some guidlines, input and advice.
Thanks!
Enat