Frosty_47
New Member
Good morning everyone !
I just overlooked your comments (thanks) and I am going to use a 20Vac transformer (will update schematic when I get home). As for the current limiting circuit, it doesn't matter whether you put it before or after the voltage regulator as long as you keep in mind the 1.25V drop. You can always play around with resistor values for the voltage regulator until you get the right Vout. Anyways, I am off to that blasted Sayal electronics to get the components. I Still need to design the board layout so hopefully everything will be ready tomorrow (unless I burn my house down ).
Thank you everyone for your help and interest in this project !
I just overlooked your comments (thanks) and I am going to use a 20Vac transformer (will update schematic when I get home). As for the current limiting circuit, it doesn't matter whether you put it before or after the voltage regulator as long as you keep in mind the 1.25V drop. You can always play around with resistor values for the voltage regulator until you get the right Vout. Anyways, I am off to that blasted Sayal electronics to get the components. I Still need to design the board layout so hopefully everything will be ready tomorrow (unless I burn my house down ).
Thank you everyone for your help and interest in this project !