amateur_24
Member
Hi
I'm having a hard time getting my programmer to work properly. Am not correct to say the status led (near the ribbon cable) should turn green as soon as I turn on my breadboard? But it's not on at all however there is definitely power because the led on breadboard is lit up. Am confused. It did managed to program the fuses once but now it aint working at all. When I switch it off it turns red which right is it not?
I'm having a hard time getting my programmer to work properly. Am not correct to say the status led (near the ribbon cable) should turn green as soon as I turn on my breadboard? But it's not on at all however there is definitely power because the led on breadboard is lit up. Am confused. It did managed to program the fuses once but now it aint working at all. When I switch it off it turns red which right is it not?
Last edited: