kentken
New Member
I am building a ignition system for a model engine using the Allegro A3245 sensor.
I had a problem with the sensor, after some time the sensor stops working right, it stays in conduction, and wont release. I am using a 12v supply and a car ignition coil.
Attached in the sch of the designs, the bottom one is found online for model engines.
Are the resistor valuses off?? Is there something else off in the design??
Thank you
Kent Kenison
I had a problem with the sensor, after some time the sensor stops working right, it stays in conduction, and wont release. I am using a 12v supply and a car ignition coil.
Attached in the sch of the designs, the bottom one is found online for model engines.
Are the resistor valuses off?? Is there something else off in the design??
Thank you
Kent Kenison