col_implant
New Member
Hi,
I'm programming an 8052 core (ADuC841) using the Aspire environment.
For some reason the ADuC debugger seems to crash whenever I start one of the timers, eg the T3 baud rate. Is this a common problem/limitation of the debugger? does anybody know a fix?
Also a more basic problem... is there a way to debug or simulate the code when using the UART? The debugger uses the UART to interface the program so obviously you cant directly communicate in debug mode. The simulator seems to take no UART inputs
Any help appreciated
C
I'm programming an 8052 core (ADuC841) using the Aspire environment.
For some reason the ADuC debugger seems to crash whenever I start one of the timers, eg the T3 baud rate. Is this a common problem/limitation of the debugger? does anybody know a fix?
Also a more basic problem... is there a way to debug or simulate the code when using the UART? The debugger uses the UART to interface the program so obviously you cant directly communicate in debug mode. The simulator seems to take no UART inputs
Any help appreciated
C
Last edited: