Hi,
Just found this board... great source of inspiration!
Let's start my first post with a question:
I have a U-Blox **broken link removed** for an r/c project that I am starting with. This device has a 20 pin flex cable connector 0.50 mm (.020") pitch bottom configuration to connect to.
I have to make a connection between this GPS receiver and a Max-232 ic. Anybody knows a good way to make a connection between these? It is very hard to solder to pins that are so near located to eachother.
What I am looking for is some kind of conversion board that has the connections a little bit further away from eachother what makes it easy to solder to them.
I appreciate your suggestions.
Jan-Dirk
Just found this board... great source of inspiration!
Let's start my first post with a question:
I have a U-Blox **broken link removed** for an r/c project that I am starting with. This device has a 20 pin flex cable connector 0.50 mm (.020") pitch bottom configuration to connect to.
I have to make a connection between this GPS receiver and a Max-232 ic. Anybody knows a good way to make a connection between these? It is very hard to solder to pins that are so near located to eachother.
What I am looking for is some kind of conversion board that has the connections a little bit further away from eachother what makes it easy to solder to them.
I appreciate your suggestions.
Jan-Dirk