Here's something quirky, I had the circuit running again and I noticed the .2 ohm resistor getting warm and started checking voltages and found it was generating 70+ volts, 33 across the load and 40 across the current limiter, but with the current limiter working good, the lights survived, and if I turned the supply down 14 to about 5 or 6, the voltage remained high until the supply got low, then the output went to 36 and stayed there, even when I turned the supply up to 20, and if I disconnected the power and then reapplied it, the voltage went back up to 70+. I also notice the frequency was around 2 - 3 KHz when the voltage was high and 109 KHz when the voltage was 33.
Any one have any ideas on how to stabilize this??
Kinarfi