Hi there, having some problems with the 12f675
btw, I'ma new pic programmer, so i'm very much a newb.
so, i have the typical blink the led on gpio.0
i have vdd and vss setup 3 volts
so, i noticed that the pic runs for about 2 seconds then stops...
i figured that there was something wrong with my bread board,maybe intermiitent connectiviy or something...
THEN, i realized that when i touched the pins with my fingure trying to push it back onto the board the pic would start again...
to make a long story short,it seems i must have vdd in gpio.3 as well????
it works when i do this, ive tried 3 other chips, same issue.
why must i supply power to this pin as well????
thanks
clonus
btw, I'ma new pic programmer, so i'm very much a newb.
so, i have the typical blink the led on gpio.0
i have vdd and vss setup 3 volts
so, i noticed that the pic runs for about 2 seconds then stops...
i figured that there was something wrong with my bread board,maybe intermiitent connectiviy or something...
THEN, i realized that when i touched the pins with my fingure trying to push it back onto the board the pic would start again...
to make a long story short,it seems i must have vdd in gpio.3 as well????
it works when i do this, ive tried 3 other chips, same issue.
why must i supply power to this pin as well????
thanks
clonus