Consider a hydraulic steering system with small electric motor atop. The maximum output torque of this motor is about 2 N.m. This output torque is input to worm gear. The output torque of the worm gear is about 20 N.m.
This steering subsystem is mounted in a prototype truck.
The requirement...
Hello,
I have to make a control system that mantains constant speed of a small car prototype using a DC gearmotor regardless of external disturbances such as slopes (small slopes).
For the development of this project I thought that a posible solution could be a control system consisting of a...
Hi guys, I’m working on repairing some electrical issues on my old car.
The gauges are a bit wonky, some don’t work and on the special occasion that they do they bounce up and down.
I am currently going through the wiring of the car, but one issue I (may) have found is the check control box...
Hi all,
I am essentially working on a research project in a lab where we would like to synchronize multiple Brushless DC motors or offset their phases (30 degrees offset, perfectly synchronized, etc.). Therefore, we are attempting to control a BLDC motor by powering the 3 coils in the proper...
Hello
I am basically new to all this... ESC stuff..
Thing is i have couple of old hdd's and dvd drive's motors lying around. I need to drive these motors for DIY projects.
So i researched a bit on them and found out that i need some sort of ESC to drive these BLDC motors and Servo controller...
I am trying to control voltage range from 1.5 to 34 using LM338 voltage regulator with 1000u capacitor at the input 430u capacitor at the output with
potentiometer @ the adjustment terminal.
I have 37v and around 5 Amps current at the Vout but when i try to reduce the voltage using...