Analogue Robot
Member
Hello.
I've produced an Eagle board (autorouted from a schematic), however the copper pads around certain components (mostly resistors) are too small for my liking. I wish to enlarge these in Eagle while leaving others untouched.
Ideally, I would like to get these resistor pads to be the same size (and shape if possible) as those used in Eagle's default 18-pin DIL.
I have tried enlarging the pads using the DRC page (Tools > DRC > Restring > Pads): Unfortunately, this method enlarges all pads, even those whose size is already fine, and then leads to numerous track overlap problems.
Is there a straightforward method for altering the size (and /or shape) of the individual resistor pads without interfering with everything else?
Thanks in advance.
Analogue.
I've produced an Eagle board (autorouted from a schematic), however the copper pads around certain components (mostly resistors) are too small for my liking. I wish to enlarge these in Eagle while leaving others untouched.
Ideally, I would like to get these resistor pads to be the same size (and shape if possible) as those used in Eagle's default 18-pin DIL.
I have tried enlarging the pads using the DRC page (Tools > DRC > Restring > Pads): Unfortunately, this method enlarges all pads, even those whose size is already fine, and then leads to numerous track overlap problems.
Is there a straightforward method for altering the size (and /or shape) of the individual resistor pads without interfering with everything else?
Thanks in advance.
Analogue.