I have attached a link to the picture of the LED module I received. It is 220 volts but it is my fault for miss reading the listing.
Is there any way to modify the board that I have to allow it to work at 120-volt?
I have pictures of the one in my hand but the image is to large for this forum to accept.
https://goo.gl/images/YbTjKP
The blue disks at the end have printed on them.
HVR 07K 471
any ideas? Since it seems the same board works for 120 or 220, I was hoping to paralell some tracks that must be in series right now.
I connected it to 120V and not even a dim glow.
thank you
Is there any way to modify the board that I have to allow it to work at 120-volt?
I have pictures of the one in my hand but the image is to large for this forum to accept.
https://goo.gl/images/YbTjKP
The blue disks at the end have printed on them.
HVR 07K 471
any ideas? Since it seems the same board works for 120 or 220, I was hoping to paralell some tracks that must be in series right now.
I connected it to 120V and not even a dim glow.
thank you