I think i posted this yesterday. seems that this post went missing
OK looking at the diagram below, the Vgs of the MOSGETS are being supplied with 12V from the power supply.
After reading through some mosfet material, it seems that the mosfet Id and Rds is controlled solely by the Vgs.
I circled the 2 resistors at the N-channel gate. Are they necessary? since the gate is controlled solely by voltage
Thx in advance for any comments
OK looking at the diagram below, the Vgs of the MOSGETS are being supplied with 12V from the power supply.
After reading through some mosfet material, it seems that the mosfet Id and Rds is controlled solely by the Vgs.
I circled the 2 resistors at the N-channel gate. Are they necessary? since the gate is controlled solely by voltage
Thx in advance for any comments