THere is a PCB-mounted GPS module but it's antenna isn't built in. On the datasheet it says to run the antenna pin to the antenna (I presume some 50ohm SMA jack that an antenna connects to) with a 50 ohm microstrip.
Is there any way to accomplish the same thing without actually needing ot make a special PCB which would cost a ton in itself.
THe module is an LEA-5 from uBlox but I don't think that information is too pertinent.
Is there any way to accomplish the same thing without actually needing ot make a special PCB which would cost a ton in itself.
THe module is an LEA-5 from uBlox but I don't think that information is too pertinent.