justDIY
Active Member
what is the 'recommended' method for keeping a ground plane / supply plane (drawn with the polygon command) out of certain areas, like the little 'nubs' it likes to creep in toward IC pins and such...
I've been using bRestrict and the rectangle command, however, when I run a DRC, it complains about traces or pads being in the restricted area ... I don't want to exclude pads or traces, just the plane
I've been using bRestrict and the rectangle command, however, when I run a DRC, it complains about traces or pads being in the restricted area ... I don't want to exclude pads or traces, just the plane