Hi,
I have a circuit that I'm simulating and would like to substitute a resistor for a motor.
I don't know much about the motor other then that it runs "kinda fast" when a 5 volt battery is connected to it... I'm not sure how much current is going through the motor and I don't have a good way to test it...
Here is the circuit that I'm using to simulate my design now...
(see attached schematic & simulation)
the current through R3 is about 100 mA... is that kinda typical for a motor?
Thanks,
V$h3r
I have a circuit that I'm simulating and would like to substitute a resistor for a motor.
I don't know much about the motor other then that it runs "kinda fast" when a 5 volt battery is connected to it... I'm not sure how much current is going through the motor and I don't have a good way to test it...
Here is the circuit that I'm using to simulate my design now...
(see attached schematic & simulation)
the current through R3 is about 100 mA... is that kinda typical for a motor?
Thanks,
V$h3r