BuffaloEngineer
Member
I want to get a set of terminal crimpers for the C-Grid III series from Molex - I think this is a pretty popular series for hobbyists/prototyping, 0.1" pitch connectors.
I'm not too keen to buy the Molex brand ones for $300+... Does anyone else make cheaper ratcheting crimpers for this size terminal?
Or what are some other good ways to crimp terminals of various sizes? Thanks!
C-Grid III link:
https://www.molex.com/molex/product...troduction&parentKey=wire_to_board_connectors
Molex hand crimp tool link:
https://www.molex.com/molex/product...ml&part=active/0901190109_CRIMP_TERMINALS.xml
I'm not too keen to buy the Molex brand ones for $300+... Does anyone else make cheaper ratcheting crimpers for this size terminal?
Or what are some other good ways to crimp terminals of various sizes? Thanks!
C-Grid III link:
https://www.molex.com/molex/product...troduction&parentKey=wire_to_board_connectors
Molex hand crimp tool link:
https://www.molex.com/molex/product...ml&part=active/0901190109_CRIMP_TERMINALS.xml