CorySCline
New Member
Hello all! I'd like to thank anyone in advance for their assistance being offered. I am building a small guitar amp as my first project. I have made some progress and believe I am almost there, but I would like to present what I have so far and get advice on if I have messed up anywhere or not I have also EXCLUDED the J2 Jack from the final design.
PARTS LIST:
R1: 22K 1/4W Resistor
C1: 10µF 25V Electrolytic Capacitor
C2: 100nF 63V Polyester or Ceramic Capacitor
C3: 220µF 25V Electrolytic Capacitor
IC1: TDA7052 Audio power amplifier IC
J1,J2: 6.3mm Stereo Jack sockets (switched)
SPKR: 8 Ohm Loudspeaker
B1: 9V PP3 Battery
This is the list I am about to order from mouser.com: (Links included)
R1: Carbon Composition Resistors 1/4W 22K OHM 5%
C1: Aluminum Electrolytic Capacitors - Leaded 25volts 10uF 4X7mm L/S=1.5mm Bulk
C2: Polyester Film Capacitors 0.1uF 400VDC/200VAC 10%
C3: Aluminum Electrolytic Capacitors - Leaded 220uF 25volts 20%
IC1: Audio Amplifiers 1W BTL MONO AMP W/VOL CTRL
J1,J2: Phone Connectors 1/4 STEREO SWITCHED
SPKR: Speakers & Transducers 30 x 16.5mm 2W
Battery Clip: PP3 Battery Holder
I anything is incorrect, I would appreciate a mouser.com link to the correct part, however, that is not necessary.
PARTS LIST:
R1: 22K 1/4W Resistor
C1: 10µF 25V Electrolytic Capacitor
C2: 100nF 63V Polyester or Ceramic Capacitor
C3: 220µF 25V Electrolytic Capacitor
IC1: TDA7052 Audio power amplifier IC
J1,J2: 6.3mm Stereo Jack sockets (switched)
SPKR: 8 Ohm Loudspeaker
B1: 9V PP3 Battery
This is the list I am about to order from mouser.com: (Links included)
R1: Carbon Composition Resistors 1/4W 22K OHM 5%
C1: Aluminum Electrolytic Capacitors - Leaded 25volts 10uF 4X7mm L/S=1.5mm Bulk
C2: Polyester Film Capacitors 0.1uF 400VDC/200VAC 10%
C3: Aluminum Electrolytic Capacitors - Leaded 220uF 25volts 20%
IC1: Audio Amplifiers 1W BTL MONO AMP W/VOL CTRL
J1,J2: Phone Connectors 1/4 STEREO SWITCHED
SPKR: Speakers & Transducers 30 x 16.5mm 2W
Battery Clip: PP3 Battery Holder
I anything is incorrect, I would appreciate a mouser.com link to the correct part, however, that is not necessary.