Ok, I'm more used to pic's when it comes to this.
I'd like to over complicate my bicycle lights with an Attiny85, the lights are dynamo powered.
Coding the system and the hardware are no problem for me, however I was wondering how the attiny would cope with the supply voltage going up & down being dynamo powered, well actually its an alternator, the voltage comes up to enough to run the lights at walking speed but for electronics the 1 second it takes is a very long time.
Is there a power up timer on this chip?, and can I enable it using the arduino ide?, or is it enabled by default.
I'd like to over complicate my bicycle lights with an Attiny85, the lights are dynamo powered.
Coding the system and the hardware are no problem for me, however I was wondering how the attiny would cope with the supply voltage going up & down being dynamo powered, well actually its an alternator, the voltage comes up to enough to run the lights at walking speed but for electronics the 1 second it takes is a very long time.
Is there a power up timer on this chip?, and can I enable it using the arduino ide?, or is it enabled by default.