T Tevfik New Member Oct 22, 2003 #1 where can i find the information about control the parallel port with turbo pascal programming? or something else with turbo pascal (robotics)
where can i find the information about control the parallel port with turbo pascal programming? or something else with turbo pascal (robotics)
C crust Member Oct 23, 2003 #2 I have not used turbo pascal in many years, but I believe that there is a port array you can use, somthing like the following ... This should take the hex value A5 and write it to the port at address hex 378. Port[$378] := $A5;
I have not used turbo pascal in many years, but I believe that there is a port array you can use, somthing like the following ... This should take the hex value A5 and write it to the port at address hex 378. Port[$378] := $A5;
Exo Active Member Oct 23, 2003 #3 You should check the adress of the port first, it isn't 378 in all systems **broken link removed**
Optikon New Member Oct 27, 2003 #4 Turbo pascal?! Hehehe.. sorry, you must be trapped in a time rift or something.Oh, I remember those days well.
Turbo pascal?! Hehehe.. sorry, you must be trapped in a time rift or something.Oh, I remember those days well.