Hello everybody, I made in Spice the circuit that you see in the photos.
The picture with the blue font shows the circuit, and is correct as it is from our professor.
The other circuit was created by me in Spice and as far as I see they are the same.
My problem is that when i run simulation is Spice the voltage output (the yellow marker) is zero when it should not be!!
If you could help me you would also save me!!!
Thnx a lot in advance!!
I believe you have the N-channel and P-channel MOSFETS interchanged (look at the N and P designations). The symbol your professor used for MOSFETs is not common and is drawn with the arrow in the source lead (similar to a BJT symbol having the arrow in the emitter lead) instead of in the substrate lead as your symbols do. When you do that, the arrow directions are reversed.
in addition to previous comments, you may want to check to circuit, and in particular voltages.
second image shows four of them (Vdd, Vss, Vin, Vbias) while your schematic only has three.